How to extend the life of the kneader

kneading machine should be done carefully, so every detail should be taken into account. Special attention should be paid to the hydraulic cylinder of the kneading machine. Strict requirements are the guarantee for the normal operation of the equipment.

Maintenance of the hydraulic cylinder of the kneader Pay attention to whether there is oil leakage and ensure the cleanliness of the piston rod. For the maintenance of vacuum pump, please refer to the instruction manual of vacuum pump. Do not run without water. The buffer tank should be drained regularly. Heating system Steam heating system should regularly check the valve pipeline, it is important to check the safety valve, to avoid the mixing cylinder jacket overload pressure. For the heat transfer oil heating system, it is strictly forbidden to dry the electric heating tank, and pay attention to check the amount of heat transfer oil in the house. With the loss of heat transfer oil, add it at any time.

shaft seal part of the shaft seal using tetrafluoroethylene V-ring or PTFE packing, or a combination of the two. Daily inspection kneader hydraulic cylinder shaft seal should not be too loose, should be adjusted to a slightly compressed state, but not too strong. The shaft seal part should be maintained once every six months, remove the seal seat, clean the journal and seal seat chamber with silicone oil, replace the V-ring or PTFE packing, and adopt oblique incision. Kneading and combination in each shift, cleaning the mixing cylinder mouth and closing the upper cover.